Home
Back
Ohm's Law:
| From: | To: |
Motor winding resistance is a critical parameter that indicates the electrical resistance of the copper windings in an electric motor. It helps in assessing the health and performance of the motor windings.
The calculator uses Ohm's law:
Where:
Explanation: The equation calculates electrical resistance by dividing the voltage applied across the winding by the current flowing through it.
Details: Measuring winding resistance is essential for motor maintenance, fault detection, efficiency calculation, and ensuring proper motor operation under various load conditions.
Tips: Enter voltage in volts and current in amps. Both values must be positive numbers greater than zero for accurate calculation.
Q1: Why is winding resistance important for motor performance?
A: Winding resistance affects motor efficiency, heat generation, and voltage drop. Higher resistance can indicate winding damage or poor connections.
Q2: What are typical winding resistance values?
A: Resistance values vary significantly based on motor size, type, and design. Small motors may have resistances from 0.1-10 ohms, while larger motors typically have lower resistances.
Q3: When should winding resistance be measured?
A: Resistance should be measured during motor installation, routine maintenance, and when troubleshooting motor performance issues or suspected winding faults.
Q4: How does temperature affect winding resistance?
A: Copper resistance increases with temperature (approximately 0.4% per °C). Measurements should be corrected to standard temperature (usually 20°C or 25°C) for accurate comparisons.
Q5: Can this calculator be used for AC motor windings?
A: Yes, but for accurate results, use DC measurements as AC measurements include inductive reactance that affects the impedance reading.